CMOD S6は、ザイリンクス製Spartan-6 LX4のFPGAを搭載した48ピンDIPタイプのボードです。

搭載IC	Xilinx Spartan-6 XC6SLX4-2CPG196 FPGA

The Digilent Cmod S6 is a small、 48-pin DIP form factor board built around a Xilinx Spartan®-6 LX4 FPGA. The board also includes a programming ROM、 clock source、 USB programming and data transfer circuit、 power supplies、 and basic I/O devices. There are 46 FPGA I/O signals that are routed to 100-mil-spaced through-hole pins、 making the Cmod S6 well-suited for use with solderless breadboards. At just .7” by 2.6”、 it can also be loaded in a standard socket and used in embedded systems.

The FPGA on the Cmod S6 can be configured in several ways - from a PC using the on-board Adept USB interface or from the on-board Quad-SPI Flash memory. Configuration files can be programmed using Xilinx's ISE® 14.2 (or higher) development tools、 using Digilent's Adept system、 or using older versions of the Xilinx tools if Adept is also installed. Xilinx's ISE/iMPACT™ programming tool and Digilent's Adept tool will recognize the board and/or FPGA when the board is attached to a PC using a USB A to micro-B cable.

Xilinx's iMPACT tool and Digilent's Adept can both be used to program the FPGA and on-board QSPI ROM. Please refer to the ISE and/or Adept documentation for more information on using the configuration software.

Features:
・Xilinx Spartan-6 XC6SLX4-2CPG196 FPGA
・600 slices (each with 4 LUTs and eight flip-flops)
・8 DSP slices
・216Kbits of block RAM
・2 CMTs (4 DCMs and 2 PLLs)
・16 MB Spansion® Quad SPI Flash for storing FPGA configurations and/or user data
・46 FPGA GPIO signals brought to DIP pins
・Two on-board clock sources
・Requires a USB A to micro-B USB cable for configuration (not included)
・4 user LEDs and 2 user buttons
・On-board Adept USB2 port for configuration、 test、 and communications interfaces